Skip to main content
eToll activation
Albert Basiul avatar
Written by Albert Basiul
Updated over 7 months ago

Description: The document describes the steps that must be taken to activate the eToll functionality (including the need to change the configuration, as well as the firmware update, activation in the Polish PUESC system)

Cause: client / manager asks to activate eToll functionality

Actions:

  1. first of all, you need to make sure that it is the activation of eToll that is needed, after which you will need to find objects in the "Device cfg update" tab by entering the plate number or imei of the object

    mceclip0.png



    it will be necessary to perform basic actions with the configuration according to the instructions for the "requesting configuration" link



  2. after receiving the current configuration of the tracker ("requesting configuration" link), it will be necessary to check and adjust important parameters in configuration.

    Open it in the configurator;

    mceclip1.png
    mceclip2.png
  3. Check if there are no functionalities configured that would initiate profile switching (Operator list, profile switching by other IOs, etc.);

    Check if 4,5,6 from the end IO slots are free in the 1st profile:

    mceclip3.png
  4. activate protocol v1.1 for 4th generation trackers.

    mceclip4.png
  5. mceclip5.png
  6. Save and upload configuration to device
    Configuration with identical Profile 1 and profile 3 settings should be saved and uploaded to the device.

    mceclip7.png
    mceclip6.png
  7. Before updating the configuration, it is recommended to first update the firmware to the latest versions, only after a successful firmware update, you need to update the configuration.

    mceclip8.png
    mceclip9.png

    mceclip10.png
  8. upload configuration to the cloud in "device cfg update" tab

    mceclip11.png
    mceclip12.png
  9. Upload configuration to device

    mceclip13.png
  10. When the configuration update is completed and the status "File successfully Updated" is displayed, you will need to similarly Upload a prepared DIFF file by finding it from the instructions (https://ruptela.atlassian.net/wiki/spaces/RnD/pages/1923121178/eToll+instructions+for+operations )

    mceclip14.png
    mceclip15.png
  11. send SMS command "reset" after successful uploading.

    mceclip16.png
  12. To activate etoll service and generate a Locator ID, use the instruction down below:

    https://ruptela.atlassian.net/wiki/spaces/RnD/pages/2297888769/eTOLL+service+provisioning+v4.0

Did this answer your question?